GBAmp3.5
About
GBAmp is a little but powerful amplifier module made to fit your favourite Game Boy.Most Game Boys has pretty low spekaer volume, but GBAmp can make it sound so that your neighbours can hear it :) GBAmp is a "Hi-Fi" grade cutting edge industrial Class-K amplifier with AGC which is more power efficient than Game Boy internal amplifier. This can help your batteries last longer.
You can also read the full GBAmp story.
New in version 3.5
- Cutting edge industrial Class-K amplifier with AGC.
- Embedded boost power supply for more efficiency.
- It's round! Yep, doughnut like.
- Cool keyring thingie included.
- It can be attached to the speaker to make a neat speak-burger!
- Speak-burger has better and cleaner fit inside your Game Boy.
- Game Boy Advance SP supported.
Buy
You can buy new GBAmp3.6 for $20, USDT or Binance Pay accepted. Write me a message to Email or Twitter or Telegram at https://t.me/egaistekHow to Install
Select your Game Boy model to get installation guide
You will need
- 7 wires of AWG 28-30
- Basic soldering iron and some solder
- Skills
- Pink area should be isolated with some tape!
You will need
- 7 wires (or 5 wires for speak-burger) of AWG 28-30
- Basic soldering iron and some solder
- New slim speaker (included with speak-burger) (but original works too) for better fit and loudness
- Skills
- N/P pads should be soldered to the speaker unless you have ordered speak-burger!
You will need
- 7 wires (or 5 wires for speak-burger) of AWG 28-30
- Basic soldering iron and some solder
- New slim speaker or speak-burger, original speaker would not let module to fit!
- Skills
- N/P pads should be soldered to the speaker unless you have ordered speak-burger!
You will need
- 7 wires (or 5 wires for speak-burger) of AWG 28-30
- Basic soldering iron and some solder
- Original or new slim speaker or speak-burger
- Special version of GBAmp3.5 for GBA
- Mad Skills
- N/P pads should be soldered to the speaker unless you have ordered speak-burger!
Follow wires guide picture to see where to solder each wire.
Put module as shown on installed picture, otherwise it would not fit.
Pull up pin 11:
Wiring from the top side of pcb, also GBAmp would sit there:
Then solder 2 power wires to the bottom side of pcb:
Installed:
You will need
- 7 wires of AWG 28-30
- Basic soldering iron and some solder
- Original or new slim speaker
- Special version of GBAmp3.5 for GBA
- Pink area should be isolated with some tape!
- Make sure your GBASP has pcb that looks like this one, others are not supported!
Follow wires guide picture to see where to solder each wire.
Put module as shown on installed picture, otherwise it would not fit.
Solder these 2 pads in blue together:
Cut out this wall marked in red:
Wiring:
Installed:
